Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 12-10-2019, 06:39 PM   #41
T&A Flathead
Member
 
Join Date: Jul 2011
Location: Pewaukee, WI (Milwaukee)
Posts: 50
Default Re: F 150 OD trans

Quote:
Originally Posted by MAG View Post
"At the moment I’m dealing with moser engineering on splining the shaft of the transmission. "They have no recollection of doing these for others in the past."

I don't understand this. I just got two of them back last week from Moser. And I have had a couple others done in past few years. They cut them to length, splined and drilled/tapped the end for the u-joint. I send them a Model A rear transmission shaft and a u-joint to use as reference/guide. Never had any problem getting them to do it or with their work. They can no longer spline the drive shaft because it is too long for their equipment.
I am needing 2 shafts done. Have you made a drawing or instructions for moser so they get it right. I want to send them mine as well. Thanks.
T&A Flathead is offline   Reply With Quote
Old 12-10-2019, 06:44 PM   #42
T&A Flathead
Member
 
Join Date: Jul 2011
Location: Pewaukee, WI (Milwaukee)
Posts: 50
Default Re: F 150 OD trans

Also do you know of moser re-hardens the shaft.
T&A Flathead is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 12-11-2019, 04:23 PM   #43
Ruth
Senior Member
 
Join Date: May 2016
Location: Glide, Oregon
Posts: 1,334
Default Re: F 150 OD trans

Quote:
Originally Posted by CarlG View Post
The torque tube, drive shaft, and radius rods all have to be shortened about an inch or so. All that is included in Dave’s kit.
Someone mentioned Dave Delmue's kit cost $3800? Can I assume this includes the trans? If so this doesn't sound too bad considering if you went with a Mitchell and wanted a syncro trans with an O/D you would have to buy a transmission and an O/D.

Last edited by Ruth; 12-11-2019 at 04:38 PM.
Ruth is offline   Reply With Quote
Old 12-11-2019, 08:29 PM   #44
Phil Brown
Senior Member
 
Phil Brown's Avatar
 
Join Date: May 2010
Location: Santee Calif.
Posts: 491
Default Re: F 150 OD trans

Daves kit includes the trans, AA bell housing, shortened torque tube and driveshaft and radius rods, pedal and e-brake brackets,clutch disk.
Or another way, pretty much everything you need
Phil Brown is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:12 AM.