crank shaft housing stripped can't align nut to dimple to time car
Husband's model a out of time . Purchased a hand crank only to find out the
bolt that turns the crank is stripped and handle slips off. Need to time engine and align nut to dimple with hand crank Needs solutions at wife wants horse but have to sell the model A it needs to run! Rare case of substituting horse for car but according to wife at least this one runs! Need advice ASAP! With 3 burly men(neighbors) got crankshaft to move 2 full revolutions without bolt seating in dimple. What is wrong here?
Last edited by BuckeyemodelA; 07-10-2019 at 08:34 PM.
Reason: additional information on status
|
07-10-2019, 07:46 PM
Threaded Mode