Harmon Collins build thread ...

[BUBBAS IGNITION]

Originally Posted by STAN WHITE

Bubba A few questions. First I purchased two of your Condensers they are very nice, Very satisfied. My question is on the Blue Bosch 12 volt coils. I understand that they are 3 Ohms and have a built in resister. I think above mentioned that a resistor is not needed with a 3 ohm coil. So I am alittle confused? Also where should I buy 2 ea Bosch coiles . Do you handel that? Plus looks to me that I might have to make a new brkt to hold condensers on a H&C Distributor.Does the length of the wire being longer should I stay with the same Gage? I have not ran this Engine since 1989. I was running it with a H&C Ignition I just bolted it up and it ran great. I might have been over doing it but it would go to 6K rpm No problem. !/4 X5 276 C I. Running a Potvin .425 Cam. Ed Bingly Engine. I also have two new H&C Distributors that I purchaed 35 Years Ago. Might be willing to sell one. Thanks for any info that you can privide. Stan White. 775 265 5333 Gardnerville,Nevada

Bosch coils amazon.com Bosch blue 00012

[spendingtheirinheritance]

Bubba

The suspense is killing me. Any new progress on the H-C's?

[mfirth]

Bubba, good to see you "at it' again. Hope you are doing well health wise.