|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-16-2019, 06:37 PM | #1 |
Senior Member
Join Date: May 2010
Location: Santee, California
Posts: 3,505
|
J & M crack repair / Also Lifter use
J & M, In your photo in my earlier thread, I see your repair has locks which cross the stitching. The components necessary to do the job are extremely expensive in the "Lock and Stitch" method. Too many components for the average guy. I Pm'd you with this question that I will repeat here. With my crack, can a reasonable repair that will last, be made with the tapered screws, and tap?
I received the question regarding how thick is the top of the lifter in my earlier inquiry. Using a straight stem valve with a Mushroom valve type lifter. I found that to be .126" as the least and .205" as the thickest and the average about .130". So, there is a lot of variability. With that info, does it sound like they can be used together? |
12-17-2019, 09:45 AM | #2 |
Senior Member
Join Date: Oct 2010
Location: 40 Mt.Vickery Rd. Southborough,MA 508-460-0733
Posts: 352
|
Re: J & M crack repair / Also Lifter use
Hello Russ: I don't come on Ford barn everyday ,just once a week when I have free time. Sorry about not getting back to you.
The way that the crack repair is done, is the threaded pins are tapered like a pipe plug and are 120 degree pitch thread. They pull each other together and the locks keep it from ever expanding again. Won't break in same spot. To try and do it your way you need to overlap the screws by 50 percent to keep them in suspension. Irontite makes a thread sealer you could use as you install the screws. Use the smallest screws you can just big enough to fill the crack. |
Sponsored Links (Register now to hide all advertisements) |
|
12-17-2019, 12:11 PM | #3 | |
Senior Member
Join Date: May 2010
Location: Santee, California
Posts: 3,505
|
Re: J & M crack repair / Also Lifter use
Quote:
Most appreciative of your counsel. |
|
12-18-2019, 08:53 AM | #4 | |
Senior Member
Join Date: Oct 2010
Location: 40 Mt.Vickery Rd. Southborough,MA 508-460-0733
Posts: 352
|
Re: J & M crack repair / Also Lifter use
Sponsored Links (Register now to hide all advertisements)
Quote:
That's their method and as you've mentioned expensive. Though theirs is also a 120 degree pitch thread that pulls metal together. You won't have that advantage using your screws. That's why i mentioned the "Irontite" sealer to use on threads. If you notice the pictures of our crack repairs as I mentioned you have to drill and tap right on the screws by approx 50% to keep them tight going along length of crack and across it. Depends on how long your crack is for amount of stitches needed to go across. |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|