07-10-2022, 01:38 AM | #1 |
Senior Member
Join Date: Sep 2016
Location: sydney australia
Posts: 1,033
|
drive axle key
axle key has taper on one end whats correct fitment ???
|
07-10-2022, 01:49 AM | #2 |
Senior Member
Join Date: May 2010
Location: Yakima Washington
Posts: 913
|
Re: drive axle key
Taper goes inboard on the bottom.
Bill |
Sponsored Links (Register now to hide all advertisements) |
|
07-10-2022, 02:37 AM | #3 |
Senior Member
Join Date: Sep 2016
Location: sydney australia
Posts: 1,033
|
Re: drive axle key
thanks
|
07-10-2022, 02:44 AM | #4 |
Senior Member
Join Date: May 2010
Location: East Shore of LAKE HOUSTON
Posts: 11,113
|
Re: drive axle key
Sponsored Links (Register now to hide all advertisements)
Bill is absolutely correct....TAPER INBOARD, FACING DOWN in keyway. The picture BELOW shows inboard, tapered end of keyway. It's obvious how tapered key must fit this diminishing taper in keyway. NOTE as an aside, the crack forming in axle right where the inboard end of slot terminates. This crack is the result of NOT tightening that giant drum retaining nut on axle end to proper torque, in other words....nut TOO LOOSE! Coop Here's one that broke on Capt. Kirk's '35 Cabriolet. He said that the big nut took hardly any effort to remove. They've gotta be TIGHT-TIGHT! |
|
|
Sponsored Links (Register now to hide all advertisements) |
|