Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 10-30-2012, 09:28 PM   #1
bill44
Member
 
bill44's Avatar
 
Join Date: Oct 2012
Location: Auburn, CA
Posts: 64
Default V8 Clutch

I put in a V8 pressure plate and I have had it fail twice in past year. Each time the pin that holds the fingers has come out far enough that the finger no longer will function. The first time it happened we found that a keeper on the end of the pin had come off or was never installed. I replaced the keeper and now it has happened again. It seems like a bad design to use a keeper instead of another positive method to keep the pin in place. I am getting tired of pulling the engine for this problem. Has anyone had this problem or know of a better clutch to avoid this in the future. I got the clutch new from Vintage Ford
bill44 is offline   Reply With Quote
Old 10-30-2012, 09:53 PM   #2
oldredford
Senior Member
 
Join Date: May 2010
Location: Moncks Corner, SC
Posts: 439
Default Re: V8 Clutch

All made in China. I always send my old USA clutch to Ft. Wayne clutch and have it reworked. Never a problem.
oldredford is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 10-31-2012, 10:43 AM   #3
Jim Brierley
Senior Member
 
Join Date: Jun 2010
Location: Temecula, CA
Posts: 4,085
Default Re: V8 Clutch

Sponsored Links (Register now to hide all advertisements)
Me too, USA is the way to go.
Jim Brierley is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:21 PM.