Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 05-15-2019, 11:40 AM   #1
Ian in Mississauga
Senior Member
 
Join Date: May 2010
Posts: 136
Default Flywheel housing to block bolt torque

I keep striking out with this specification, my searches keep giving me the flywheel to crankshaft spec instead. Any advice?
Thanks Ian
Ian in Mississauga is offline   Reply With Quote
Old 05-15-2019, 11:51 AM   #2
J Franklin
Senior Member
 
J Franklin's Avatar
 
Join Date: May 2010
Location: Oregon
Posts: 5,947
Default Re: Flywheel housing to block bolt torque

Just snug them up, there is no torque spec.
J Franklin is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 05-15-2019, 12:18 PM   #3
Dick Steinkamp
Senior Member
 
Dick Steinkamp's Avatar
 
Join Date: Apr 2016
Location: Bellingham, WA
Posts: 1,163
Default Re: Flywheel housing to block bolt torque

Sponsored Links (Register now to hide all advertisements)
Here's a chart...

https://www.imperialsupplies.com/pdf...rqueCharts.pdf

Scroll down a little to the "Bolt Clamp Loads" section.
__________________
All steel from pedal to wheel
Dick Steinkamp is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:17 PM.