|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-30-2022, 08:20 AM | #1 |
Senior Member
Join Date: May 2014
Location: Ontario
Posts: 207
|
Is anyone remaking this cage bracket?
Hello again with my endless questions, is any one remaking this metal cage/retainer ? Any help would be appreciated thanks
Last edited by rust revival; 04-30-2022 at 09:02 AM. |
04-30-2022, 08:55 AM | #2 |
Senior Member
Join Date: Feb 2019
Location: Erie Pa
Posts: 689
|
Re: Is anyone remaking this cage bracket?
Hello, they make the tapping plate that goes into the retainer, I bent retainer out of sheet metal and welded it on .Snyders has tapping plates for both lock and dovetail.
|
Sponsored Links (Register now to hide all advertisements) |
|
04-30-2022, 10:13 AM | #3 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,439
|
Re: Is anyone remaking this cage bracket?
I just fabricate my own for captive nuts and such. I use extruded aluminum angle as soft jaws in my vice and it works as a metal brake for little stuff like that.
|
04-30-2022, 05:30 PM | #4 |
Senior Member
Join Date: May 2014
Location: Ontario
Posts: 207
|
Re: Is anyone remaking this cage bracket?
Ok thanks fellas, hum, maybe a small market for a run of these, if no one is making them?
|
05-01-2022, 11:45 AM | #5 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,439
|
Re: Is anyone remaking this cage bracket?
Some of the ones for the single captive nuts are available in one or two different sizes but the doubles I haven't seen yet. Ford wasn't the only company to use captive nuts but not all are designed the same way.
|
06-19-2022, 06:27 PM | #6 |
Senior Member
Join Date: May 2014
Location: Ontario
Posts: 207
|
Re: Is anyone remaking this cage bracket?
Sponsored Links (Register now to hide all advertisements)
Last edited by rust revival; 06-20-2022 at 09:17 PM. |
06-20-2022, 10:30 AM | #7 |
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 5,046
|
Re: Is anyone remaking this cage bracket?
Looking good, thanks for the update.
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! |
|
|
Sponsored Links (Register now to hide all advertisements) |
|