|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-27-2020, 10:13 AM | #1 |
Senior Member
Join Date: Oct 2014
Location: Kentucky
Posts: 502
|
AA 1930 king pins bushings needed
Looking for source for set of AA 1930 king pins and bushings
Thanks |
10-27-2020, 11:03 AM | #2 |
Senior Member
Join Date: May 2016
Location: Scottsdale, Arizona
Posts: 611
|
Re: AA 1930 king pins bushings needed
Good Morning...You might try Arizona Model A...Sammy Guthrie...480-782-0266. He might have good used ones...or NOS...Ernie in Arizona
|
Sponsored Links (Register now to hide all advertisements) |
|
10-27-2020, 11:18 AM | #3 |
Senior Member
Join Date: Aug 2016
Location: West Virginia
Posts: 430
|
Re: AA 1930 king pins bushings needed
Snyders has the bushings, the pins a little harder, nos if you can find them.
|
10-27-2020, 02:50 PM | #4 |
Junior Member
Join Date: Nov 2017
Location: Arvada, CO
Posts: 28
|
Re: AA 1930 king pins bushings needed
I would call Steve ar Berts.
|
10-27-2020, 03:14 PM | #5 |
Senior Member
Join Date: May 2010
Location: Oregon
Posts: 5,946
|
Re: AA 1930 king pins bushings needed
Many times it is only the bushings that are needed.
|
10-27-2020, 08:28 PM | #6 |
Senior Member
Join Date: Jun 2010
Location: Eastern, CT
Posts: 527
|
Re: AA 1930 king pins bushings needed
Sponsored Links (Register now to hide all advertisements)
Red Wolf |
10-27-2020, 10:53 PM | #7 |
Senior Member
Join Date: Apr 2011
Location: Milpitas, CA
Posts: 396
|
Re: AA 1930 king pins bushings needed
Dave
I have a NOS set that I can sell to you. $100 plus shipping.
__________________
Bill Cilker, Jr Unrestored 190A Victoria 45B, 160B & 189A Victoria Association President |
10-28-2020, 06:02 AM | #8 |
Senior Member
Join Date: Aug 2016
Location: West Virginia
Posts: 430
|
Re: AA 1930 king pins bushings needed
I found a nos set at a swap meet that I think were WWII era. They didn’t have any shims and were marked wrong as to left and right. My original thrust bearings cleaned up and looked better than the ones in the set so I used them. (They were roller bearings and the replacement were ball) I found some shims from one of the on line supply places. I used Snyder’s bushings. They were better than the WWII ones and had the correct grease grooves. Grainger has a thrust bearing that I think would work but since my original ones cleaned up good I didn’t order them. I had a local truck spring shop ream the bushings.
|
11-02-2020, 10:53 AM | #9 |
Senior Member
Join Date: Oct 2014
Location: Kentucky
Posts: 502
|
Re: AA 1930 king pins bushings needed
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|