Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 08-09-2019, 08:06 PM   #1
Robin 47 ford pickup
Member
 
Join Date: Dec 2013
Location: Victoria , Australia
Posts: 52
Default head gaskets

hi guys, just wondering which head gaskets are best to use when I bore my 1940 V8 block out to 3-3/16", I was worried about gasket overhang in the combustion chambers in the piston area with std bore gaskets ?
any comments please
cheers Robin
Robin 47 ford pickup is offline   Reply With Quote
Old 08-10-2019, 12:02 AM   #2
frnkeore
Senior Member
 
frnkeore's Avatar
 
Join Date: Jul 2019
Location: Southern Oregon
Posts: 518
Default Re: head gaskets

Sponsored Links (Register now to hide all advertisements)
If it's a 24 stud engine, just use the standard 59A gaskets.
frnkeore is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 09:52 PM.