The Ford Barn

zzlegend · 02-01-2014, 08:10 PM

Just pulled my motor this morning and installed a new clutch disc and a very nice used pressure plate. What a difference. Smooth and no more chatter.

The old disc was junk.

Thanks Tom Endy for the heads up on the brattons clutch disc,,,,,
Thanks Tom W. for the pictures and the home made tool. I copied it and it made it easy for adjusting the 11/16 gap,,,,Hope you don't mind.

Thanks Steve from Berts for the pressure plate and fast shipping,,,,,,

Productive day today.

Sixseven · 02-01-2014, 08:26 PM

Did you replace the pilot bearing also? I have a wicked chatter, I'm up for the same job.

zzlegend · 02-01-2014, 08:36 PM

Yes

Sixseven · 02-01-2014, 08:53 PM

thx.

Ken

silversink · 02-01-2014, 09:23 PM

Sponsored Links (Register now to hide all advertisements)

I just did that to mine today, had a lot of chatter. Rust all over the flywheel and pressure plate and uneven wear on the disk(?). drained the oil and water has been in the crankcase so I pulled the head, sure enough a broken gasket.

02-01-2014, 08:10 PM	#1
zzlegend Senior Member Join Date: May 2010 Location: Reseda, Calif. Posts: 2,188	Clutch chatter be gone Just pulled my motor this morning and installed a new clutch disc and a very nice used pressure plate. What a difference. Smooth and no more chatter. The old disc was junk. Thanks Tom Endy for the heads up on the brattons clutch disc,,,,, Thanks Tom W. for the pictures and the home made tool. I copied it and it made it easy for adjusting the 11/16 gap,,,,Hope you don't mind. Thanks Steve from Berts for the pressure plate and fast shipping,,,,,, Productive day today.

02-01-2014, 08:26 PM	#2
Sixseven Senior Member Join Date: Jan 2014 Location: Atlanta, GA Posts: 482	Re: Clutch chatter be gone Did you replace the pilot bearing also? I have a wicked chatter, I'm up for the same job.

02-01-2014, 08:36 PM	#3
zzlegend Senior Member Join Date: May 2010 Location: Reseda, Calif. Posts: 2,188	Re: Clutch chatter be gone Yes

02-01-2014, 08:53 PM	#4
Sixseven Senior Member Join Date: Jan 2014 Location: Atlanta, GA Posts: 482	Re: Clutch chatter be gone thx. Ken

02-01-2014, 09:23 PM	#5
silversink Senior Member Join Date: Nov 2011 Location: Dayton Oregon Posts: 318	Re: Clutch chatter be gone Sponsored Links (Register now to hide all advertisements) I just did that to mine today, had a lot of chatter. Rust all over the flywheel and pressure plate and uneven wear on the disk(?). drained the oil and water has been in the crankcase so I pulled the head, sure enough a broken gasket. __________________ Hotrods don't have valve covers

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode