|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: Aug 2016
Location: Alberta
Posts: 930
|
![]()
My car has an annoying rattle that occurs at slow speed but goes away at highway speed. It's a tinny sounding rattle that sounds like it's coming from under the dash or from the firewall. There really isn;'t anything under the dash or on/around the firewall that I can find that would make such a noise but there it is. I just had the motor/trans out for a rebuild and the did not find anything on the outside of the car or under the floor that would cause it which leads me back to under the dash but there is nothing there but the gas tank. Anyone experience such a rattle and find the source??
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Apr 2014
Location: Montpelier, VT
Posts: 223
|
![]()
I had a nasty sounding rattle when the car was first started that tended to diminish as the car was driven, except on rough roads. It was the windshield frame hitting the stanchion on the passenger side (1931 roadster). Push the windshield open and see if it goes away.
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 | |
Senior Member
Join Date: Oct 2019
Location: Virginia
Posts: 140
|
![]() Quote:
I have a heat shield mounted on the exhaust over the muffler. The rear mount broke and it made a strange noise/resonance until I discovered and repaired it.
__________________
1929 Town Sedan (Briggs) 155B, Mitchell Overdrive 1935 Model 48 Tudor |
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Jun 2014
Location: Melbourne, Australia
Posts: 7,496
|
![]()
If everybody who has experienced a rattle in their Model A posts here, this thread will be the longest on the Forum!
__________________
I'm part of the only ever generation with an analogue childhood and a digital adulthood. |
![]() |
![]() |
![]() |
#5 |
Member
Join Date: May 2010
Location: Dunmore, PA
Posts: 59
|
![]()
I had a rattle that turned out to be the rod in E brake that is activated when you push the button on top to release the e brake. Drove me crazy till I found it as I thought it was dash/firewall/floorboard. Finally I just placed my finger on the button while driving , and no rattle Took it apart and covered with heat shrink tubing. Hope this helps you.
|
![]() |
![]() |
![]() |
#6 | |
Senior Member
Join Date: May 2016
Location: Glide, Oregon
Posts: 1,339
|
![]() Sponsored Links (Register now to hide all advertisements)
Quote:
![]() ![]()
__________________
Ruth "Sometimes you really DO need to read the whole thread" |
|
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: Jun 2010
Location: 34.22 N 118.36 W
Posts: 1,057
|
![]()
My shift knob does not rattle, so much for the rest of the car.............
J
__________________
As Carroll Smith wrote; All Failures are Human in Origin. |
![]() |
![]() |
![]() |
#8 |
Senior Member
Join Date: May 2010
Location: Pacific Grove, CA
Posts: 1,211
|
![]()
My granddaughter has an annoying rattle too....I just go to the den.
|
![]() |
![]() |
![]() |
#9 | |
Senior Member
Join Date: Aug 2016
Location: Alberta
Posts: 930
|
![]() Quote:
|
|
![]() |
![]() |
![]() |
#10 |
Senior Member
Join Date: Aug 2016
Location: Alberta
Posts: 930
|
![]() |
![]() |
![]() |
![]() |
#11 | |
Senior Member
Join Date: Aug 2016
Location: Alberta
Posts: 930
|
![]() Quote:
|
|
![]() |
![]() |
![]() |
#12 |
Senior Member
Join Date: Jun 2017
Location: Walla Walla, WA
Posts: 1,045
|
![]()
I had (sometimes have) a rattle from the clips that are riveted to the firewall that the hood supports go into. On one of mine, the rivets have really loosened up and I have to compensate by tightening the hood support rod just right. One of these days I will grind off the rivets and use the rivet-head screws the vendors sell, but it drove me nuts until I found it. Maybe that is your rattle.
|
![]() |
![]() |
![]() |
#13 |
Senior Member
Join Date: Jul 2018
Location: Spring Grove, Illinois
Posts: 1,371
|
![]()
Check for loose rivets and loose bolts/nuts.
__________________
"The more things change, the more they stay the same." |
![]() |
![]() |
![]() |
#14 |
Senior Member
Join Date: May 2010
Location: Long Island, NY
Posts: 3,472
|
![]()
This sneaky rattle is hard to find and very annoying.
__________________
Bob Bidonde |
![]() |
![]() |
![]() |
#15 |
Member
Join Date: Dec 2016
Location: Grants Pass, Oregon
Posts: 79
|
![]()
A club member once told if I hear strange noises coming from my Model A to just “TURN UP THE RADIO “.
|
![]() |
![]() |
![]() |
#16 |
Senior Member
Join Date: Feb 2017
Location: Zanesville Ohio USA
Posts: 268
|
![]()
Yeah, I have a strange rattle towards the front of the car right now. Sounds like a loose hose clamp or something similar. At idle or driving, rattle is there. Everything is greased. I have no idea at the moment!
__________________
1928 Niagara Blue Phaeton 1972 Olds 442 Convertible 1979 MGB -Life's Too Short To Drive Boring Cars- |
![]() |
![]() |
![]() |
#17 |
Member
Join Date: Mar 2013
Location: e tenn
Posts: 63
|
![]()
could be the advance & throttle rods in the steering columm mine do that.
|
![]() |
![]() |
![]() |
#18 |
Senior Member
Join Date: Jul 2010
Location: Pennsylvania
Posts: 1,100
|
![]()
If you have engine pans, take a look at where they mount to the oil pan. I once found that one of the ears had cracked from the vibrations, and it caused a rattle.
|
![]() |
![]() |
![]() |
#19 |
Junior Member
Join Date: Jul 2012
Location: Satsuma,AL
Posts: 15
|
![]()
the flame arrestor in my gas tank works loose and rattles. sounds like it is under the dash.
|
![]() |
![]() |
![]() |
#20 |
Senior Member
|
![]()
Reach way under the dash and make sure those clamps that mount the gas tank are tight.
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|