|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-07-2021, 12:14 PM | #1 |
Member
Join Date: May 2021
Posts: 36
|
Zenith carberater
I’m trying to set the float on a zenith according to Les Andres book the float is supposed to be 1 inch & you’re supposed to set them by the washers under the valves . Mine measures about 1& 1/16th with no washers at all under valve. They say not to bend the float. What are you supposed to do then
|
12-07-2021, 12:36 PM | #2 | |
Senior Member
Join Date: May 2010
Location: Clinton,WA/Whidbey Island
Posts: 4,118
|
Re: Zenith carberater
Quote:
__________________
www.whidbeymodelaclub.com |
|
Sponsored Links (Register now to hide all advertisements) |
|
12-07-2021, 02:01 PM | #3 |
Senior Member
Join Date: Jan 2019
Location: Germany, near Aachen
Posts: 1,159
|
Re: Zenith carberater
Randy,
there are float needle valves with different installation lengths. With sensitivity, you can adjust the float on the sheet metal.
__________________
Beste Gruesse aus Deutschland, Werner Ford Model A, Roadster, 1928 Citroen 11 CV, 1947 Hercules W 2000, 1976; (with NSU-Wankel Rotary Engine), Canadian version |
12-07-2021, 03:18 PM | #4 |
Senior Member
Join Date: May 2010
Location: brentwood, ca
Posts: 4,272
|
Re: Zenith carberater
Tom Endy covers setting the fuel level in this technical article.
http://www.santaanitaas.org/wp-conte...etor-11-07.pdf Several things can affect the float level setting. |
12-07-2021, 03:27 PM | #5 | |
Senior Member
Join Date: Aug 2018
Location: Foley, Al
Posts: 142
|
Re: Zenith carberater
Quote:
__________________
Jim |
|
12-08-2021, 11:36 AM | #6 | |
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 5,057
|
Re: Zenith carberater
Sponsored Links (Register now to hide all advertisements)
Quote:
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|