|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-14-2012, 08:54 PM | #21 |
Senior Member
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
|
Re: Front Wheel Bearings - tightness?
WOW! This question had "100" different answers.
I'll continue my tested method: High quality, high temp disc brake grease, pre-load 10 to 12 foot lbs, (that isn't much) while turning the drum, key it and drive it! I run 30,000 miles between re-packings. Bill W. (Observation in life: most folks NEVER change their ways of doing things!)
__________________
"THE ASSISTANT GURU OF STUFF" Last edited by BILL WILLIAMSON; 02-14-2012 at 09:03 PM. Reason: WISDOM TID BIT |
02-14-2012, 08:56 PM | #22 |
Senior Member
Join Date: May 2010
Location: Camino, CA.
Posts: 3,086
|
Re: Front Wheel Bearings - tightness?
I tighten mine with plyers and then back off and tighten by hand to the next cotter pin slot. Better too loose than toootight.
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|