|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-14-2022, 08:05 PM | #1 |
Member
Join Date: May 2010
Posts: 85
|
Need a dimension;34 ford
I'm installing my recored stock 34 rad and the stay rods are new. I don't plan on running a hood for a while so I need a measurement from lip of the top of the firewall in the center to the back of the rad stay rod bracket. Any help is appreciated
|
07-14-2022, 08:20 PM | #2 |
Senior Member
Join Date: May 2010
Location: Pacific Grove, CA
Posts: 1,211
|
Re: Need a dimension;34 ford
Hello S, I can do any measurements you want on my 34, but the measurement you describing would vary based on if the radiator was push forward or backward because when it’s not attached it has a lot of wiggle room, but I can give you the measurement of how mine is with the stock rods in place and tighten down
|
Sponsored Links (Register now to hide all advertisements) |
|
07-14-2022, 08:46 PM | #3 |
Member
Join Date: May 2010
Posts: 85
|
Re: Need a dimension;34 ford
Thanks Digger I'm looking for a measurement on a stock 34 with a hood and a stock rad and firewall.
|
07-14-2022, 09:14 PM | #4 |
Senior Member
Join Date: May 2010
Location: Pacific Grove, CA
Posts: 1,211
|
Re: Need a dimension;34 ford
From the front lip of the firewall to where the rods attach on the radiator rod bracket is 28.75”. See photo
|
07-14-2022, 09:20 PM | #5 |
Member
Join Date: May 2010
Posts: 85
|
Re: Need a dimension;34 ford
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|