The Ford Barn

Terry Longest · 08-11-2016, 08:51 PM

Can one of you guys tell me the correct finish for the starter rod in 1931? The Restoration Guidelines are fuzzy about it, in my opinion. I understand that in the early years it was cadmium but does that apply to later years also? Thanks in advance.

Steve Plucker · 08-11-2016, 09:22 PM

Yes...cad plate.

Pluck

Terry Longest · 08-11-2016, 09:28 PM

Sponsored Links (Register now to hide all advertisements)

Thanks Pluck. I was afraid of that.

08-11-2016, 08:51 PM	#1
Terry Longest Member Join Date: May 2010 Location: Opelika, AL Posts: 74	Starter rod finish Can one of you guys tell me the correct finish for the starter rod in 1931? The Restoration Guidelines are fuzzy about it, in my opinion. I understand that in the early years it was cadmium but does that apply to later years also? Thanks in advance.

08-11-2016, 09:22 PM	#2
Steve Plucker Senior Member Join Date: May 2010 Location: Walla Walla, Washington USA Posts: 6,011	Re: Starter rod finish Yes...cad plate. Pluck __________________ www.plucks329s.org Walla Walla (WA) Sweet A's since 1993 MARC/MAFCA member since 1978 Ford Model AA Truck Club since 1998 (LIONEL/MTH Toy Train Collector, Orange Crush Soda Collector, Steel Beer Can Collector, Old Gas Pump Collector)

08-11-2016, 09:28 PM	#3
Terry Longest Member Join Date: May 2010 Location: Opelika, AL Posts: 74	Re: Starter rod finish Sponsored Links (Register now to hide all advertisements) Thanks Pluck. I was afraid of that.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode