|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-06-2021, 12:44 PM | #21 | |
Senior Member
Join Date: Dec 2017
Location: Guthrie, OK
Posts: 1,144
|
Re: Rumble Seat Hinges part 2
On my rumble conversion I found #10 clinch nuts instead of #12 D-nuts holding the hinges. I suspect this may have been done to align repo hinges to the original trunk lid, but it's been a while since I had the repo cushions out to see.
Quote:
|
|
02-06-2021, 12:49 PM | #22 |
Member
Join Date: Dec 2016
Location: Grants Pass, Oregon
Posts: 79
|
Re: Rumble Seat Hinges part 2
I also have used the scotch tape method and other than a wrench I have also scotch taped a nut to my finger to get in tight places.
|
Sponsored Links (Register now to hide all advertisements) |
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|