|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-24-2020, 11:34 AM | #1 |
Senior Member
Join Date: Dec 2019
Location: Gardnerville, Nevada
Posts: 185
|
33 Dash instrument gage panel
I would like to know the thicknes of the engine turned gage panel on a 33 Dash as I have to make one. Thanks Stan
|
12-25-2020, 08:57 PM | #2 |
Senior Member
Join Date: May 2010
Location: Ft Mohave,Az
Posts: 1,987
|
Re: 33 Dash instrument gage panel
Stan, I made mine {from a street speed limit sign the county was replacing.
Make a set of(M-F) bucks from wood & lightly lube. Lay the aluminum on the female buck & male on top of the metal, set it in a 20 ton press go to work adding light pressure. When you get to the corners add heat & hammer gently to prevent stretching & cracking , cut out the gauge & speedo & polish. If engine turning do that before cutting the holes. |
Sponsored Links (Register now to hide all advertisements) |
|
12-25-2020, 10:37 PM | #3 |
Senior Member
Join Date: May 2010
Location: Ft Mohave,Az
Posts: 1,987
|
Re: 33 Dash instrument gage panel
Sponsored Links (Register now to hide all advertisements)
Stan ,forgot to mention to J B Weld the studs on the back for mounting. Last edited by B-O-B; 12-25-2020 at 10:42 PM. Reason: forgot a sentence |
|
|
Sponsored Links (Register now to hide all advertisements) |
|