|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-31-2015, 10:31 PM | #1 |
Junior Member
Join Date: Jan 2015
Location: Elm City, NC
Posts: 5
|
37 ford toe in/toe out setting
Front tires scrubbing on outside edge. Measuring front & back of tires, toe in of 9/16" found. How does this relate to degrees? I've read conflicting suggestions about whether toe in or toe out is better for handling on straight axle Fords, always discussed in degrees. I don't know of a shop that still does front end work on "old" straight axle Fords, so I'm trying adjust the front end myself. Any help is greatly appreciated. Thanks, Rod
Last edited by RodRocket; 02-01-2015 at 10:08 AM. Reason: I shouldn't have mentioned "camber". |
01-31-2015, 10:52 PM | #2 |
Senior Member
Join Date: May 2010
Location: Mn
Posts: 2,411
|
Re: 37 ford camber setting
This section is for "Questions to the the Editor" about this site.
You should post your questions in "General Discussion" in the Early V/8 section here, and you will get answers from the general membership.....good luck .
__________________
If mama ain't happy, ain't nobody happy. But if daddy ain't happy...RUN |
Sponsored Links (Register now to hide all advertisements) |
|
01-31-2015, 11:15 PM | #3 |
Junior Member
Join Date: Jan 2015
Location: Elm City, NC
Posts: 5
|
Re: 37 ford camber setting
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|