The Ford Barn

JunkyJud · 11-02-2018, 10:42 AM

I have a '36 LB that has an aluminum press on cam gear. The match marks aren't aligned perfectly but they are very close. The misalignment is probably about the width of the line. Will this create a noticeable problem?

Brian · 11-02-2018, 12:54 PM

No.You'll not notice any problem

Ol' Ron · 11-02-2018, 01:40 PM

I always check for split over lap, wnen both valves are open at the same time at TDC. The may vary alittle but it works OK.

JunkyJud · 11-02-2018, 03:11 PM

Sponsored Links (Register now to hide all advertisements)

Thanks fellas. I figured that it would be okay but I wanted to check.

11-02-2018, 10:42 AM	#1
JunkyJud Member Join Date: Jul 2013 Posts: 93	36 cam timing gear question I have a '36 LB that has an aluminum press on cam gear. The match marks aren't aligned perfectly but they are very close. The misalignment is probably about the width of the line. Will this create a noticeable problem?

11-02-2018, 12:54 PM	#2
Brian Senior Member Join Date: May 2010 Location: Masterton, New Zealand Posts: 3,832	Re: 36 cam timing gear question No.You'll not notice any problem __________________ Unfortunately, two half wits don't make a whole wit!

11-02-2018, 01:40 PM	#3
Ol' Ron Senior Member Join Date: May 2010 Location: Chester Vt Posts: 8,859	Re: 36 cam timing gear question I always check for split over lap, wnen both valves are open at the same time at TDC. The may vary alittle but it works OK.

11-02-2018, 03:11 PM	#4
JunkyJud Member Join Date: Jul 2013 Posts: 93	Re: 36 cam timing gear question Sponsored Links (Register now to hide all advertisements) Thanks fellas. I figured that it would be okay but I wanted to check.