|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-15-2011, 11:17 PM | #1 |
Senior Member
Join Date: Jul 2011
Location: South East Michigan
Posts: 229
|
E-Brake Handle question
I am installing hydraulic brakes on my 29 coupe,and I may have found a problem with my hand brake. On the bottom of the handle below the pivot point,there are two holes. One has the cleves,and the pawl attached with the same cleves pin. The other hole is unused. Shouldn't the cleves be on the bottom hole? I will be using the center arm on the E-brake cross shaft for my E-brake cable equlizer.
__________________
If you think SBC's are "Old School" you are not old enough. |
08-15-2011, 11:40 PM | #2 |
Senior Member
Join Date: May 2010
Location: santa cruz, calif
Posts: 2,011
|
Re: E-Brake Handle question
I think your brake lever might be off another year or other car, perhaps a 32 or later. The A has one hole and the short rod and pawl are held by the same pin.
|
Sponsored Links (Register now to hide all advertisements) |
|
08-16-2011, 09:04 AM | #3 |
Senior Member
Join Date: Jul 2011
Location: South East Michigan
Posts: 229
|
Re: E-Brake Handle question
Sponsored Links (Register now to hide all advertisements)
__________________
If you think SBC's are "Old School" you are not old enough. |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|