|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-18-2018, 05:48 PM | #1 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 3,258
|
Strombergs 97 Thread size
What's the thread size inside the fuel inlet hole in the Stromberg 97 body? Got one that the threads are stripped.
|
12-18-2018, 05:54 PM | #2 |
Senior Member
Join Date: May 2010
Location: Kerrville, Tx
Posts: 2,769
|
Re: Strombergs 97 Thread size
Common deal. Some of the rebuilders sell threaded inserts. I used to make them for my carbs. I think I used 9/16 nf bolts so half the work was done. I drilled and tapped them to whatever the threads were stock. I put the inserts in deep so the gasket still sealed on the housing and not the insert. I did not tap the housing all the way thru so the insert would bind up on the unfinished threads. They always worked pefectly.
|
Sponsored Links (Register now to hide all advertisements) |
|
12-18-2018, 06:08 PM | #3 |
Senior Member
Join Date: May 2010
Location: SLC Utah
Posts: 798
|
Re: Strombergs 97 Thread size
To answer your question, those threads are 7/16-24.
I have inserts.
__________________
RIP Tyler... My Son, Helper & Best Friend. Feb '78 to Father's Day '10. www.97-express.com ~ [email protected] |
12-18-2018, 07:20 PM | #4 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 3,258
|
Re: Strombergs 97 Thread size
Thanks !
|
12-18-2018, 08:44 PM | #5 |
Senior Member
Join Date: Aug 2012
Location: Perth, Western Australia
Posts: 2,687
|
Re: Strombergs 97 Thread size
Sponsored Links (Register now to hide all advertisements)
{Jamie is a mate of mine}
__________________
"Came too close to dying to stop living now!" |
|
|
Sponsored Links (Register now to hide all advertisements) |
|