|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-30-2016, 03:58 PM | #1 |
Junior Member
Join Date: Jul 2012
Posts: 28
|
torque tube seal and bearing race
What direction does the bearing race and the seal go for removal? Out the front or back? I have everything out including the drive shaft.
|
10-30-2016, 04:21 PM | #2 |
Senior Member
Join Date: May 2010
Location: Southern California
Posts: 3,131
|
Re: torque tube seal and bearing race
They both go out the front. Place the drive shaft vertical on a block of wood on the floor with the spline end up. Place a 1&1\16" six-point socket over the spline. Put the torque tube over it and bounce it several times. This will force the seal and the bearing race out. Best to hold a rag over the end to catch them as they come out.
Tom Endy |
Sponsored Links (Register now to hide all advertisements) |
|
10-31-2016, 05:41 AM | #3 |
Senior Member
Join Date: May 2010
Posts: 1,304
|
Re: torque tube seal and bearing race
When you reinstall the race you will see a dimple on the outside,this must align with a recess in the tube neck to locate the race . I know you know this but just in case .
John in lovely sunny morning Suffolk County England |
10-31-2016, 06:45 AM | #4 |
Senior Member
|
Re: torque tube seal and bearing race
I assume you already have the snap ring out. Not easy the first time. Very easy the sixth time. We had problems.
|
10-31-2016, 10:28 AM | #5 |
Senior Member
Join Date: Jun 2010
Location: Temecula, CA
Posts: 4,089
|
Re: torque tube seal and bearing race
Face the seal so it keeps the oil in the trans, not the rear end.
|
10-31-2016, 06:50 PM | #6 |
Senior Member
|
Re: torque tube seal and bearing race
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|