|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-25-2020, 10:31 AM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Western New York
Posts: 103
|
Cam installation issue.
Trying to install cam into block, cam is a Kiwi 100 from Tony. Cam bearings were installed at machine shop. Did not have cam when bearings were installed. Oiled bearings and journals for test fit. The cam would not slide in. The journals measures 1.797 and the cam bearing measures 1.794. I know obviously I need to go back to machine shop, any other advice? As always thanks in advance.
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:41 AM.