|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-29-2015, 06:20 AM
|
#1 |
|
Senior Member
Join Date: May 2010
Posts: 114
|
aluminum finish?
Spent some time on the Barn and was surprised at the 15 or so different solvents & soaps & etc., suggested to clean carbs and distributors. Had hoped to find some clue as to how to get that new looking finish on a carb. Not too bad on the distributors as you can clean them up decent with a rotary wire brush. But how can I make a carb look like new? Thanks, Don
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 10:24 AM.