Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 04-10-2014, 01:25 PM   #1
winchester
Junior Member
 
Join Date: May 2010
Posts: 20
Default !940 ford with charging problem

Hi I'am back, still working on my 1940 ford charging problem. Can any one tell me how many wires should be attached to the BAT terminal on the voltage regulator. This one has two and when you remove them and measure to voltage they both have 6.24 volts. Thanks Winchester
winchester is offline   Reply With Quote
Old 04-10-2014, 06:23 PM   #2
rotorwrench
Senior Member
 
rotorwrench's Avatar
 
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 11,825
Default Re: !940 ford with charging problem

Mac VanPelt has the old style schematic diagrams used by FoMoCo.
http://www.vanpeltsales.com/FH_web/F...ing1940std.jpg

Since this was a 6-volt power wire direct to the buss then they may have tapped off of it for under the hood electrical stuff. The bat connection of the regulator would be connected to the cut out pole in the diagram.
rotorwrench is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:09 PM.