Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 08-01-2020, 03:26 PM   #21
johnneilson
Senior Member
 
Join Date: Jun 2010
Location: 34.22 N 118.36 W
Posts: 489
Default Re: Port & Polish Engine

The Jr. Drags and billet parts can make lots of HP.
Back some years ago we ran "stock" Briggs classes in karts on methanol.
Must be all stock parts and castings, minimum dimensions list could almost have been QC documents for production. The motors made about 7.5 HP from a 5hp model. This with stock gas tank and carb.

Back on track to the original question about porting and polishing, every motor could benefit from cleanup to elevate mis-matched ports etc.
However, from lots of time spent on flowbench with Model A motor, I would think the stock-ish motor would not gain much at all. The higher performance the motor, the more potential gain. As Brett says, the Siamese intake port causes much limitation as to the HP potential on these motors. Winfield's two up/two down crank corrected much of this short coming by having the ports firing order 360 degrees apart.

It is a good question, John
__________________
As Carroll Smith wrote; All Failures are Human in Origin.
johnneilson is offline   Reply With Quote
Old 08-01-2020, 03:27 PM   #22
Pete
Senior Member
 
Pete's Avatar
 
Join Date: May 2010
Location: Wa.
Posts: 3,848
Default Re: Port & Polish Engine

When the quarter midgets came on the scene in the 50's our shop got involved in engine development (Continental) for them. Through the years it followed pretty much the same paths as the Briggs & Stratton and made about the same power. The biggest improvment came with the welding in tubing for ports and monster valves.
Pete is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:50 PM.