|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-23-2021, 09:32 AM | #1 |
Senior Member
Join Date: May 2010
Location: NJ
Posts: 6,189
|
Thoughts on how to straighten a '32 trans mount
I have two Ford script trans mounts (piece that the rubber ring sits in).
Sacramento Vintage Ford will vulcanize a new ring on to these pieces. One of the mounts is bowed slightly. I'd like to straighten it before I send it out. Here are my thoughts as to how to do it: 1) place it in a vise between blocks and squeeze it back straight 2) Hammer it straight on a anvil 3) Or open to other ideas. I'm assuming this is just a stamped steel piece. Thoughts on if I'm on the right track. Thanks. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|