|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-06-2021, 08:52 PM | #1 |
Senior Member
Join Date: Jul 2011
Location: lawrenceburg, tn
Posts: 128
|
29 ccpu frame welting & body blocks
Hi , I’ve read some post & the frame welting goes on the frame then the splash aprons. The front body block under cowl the rubber shins go between the bottom of cab & on top of the apron correct ? On The center & rear cab blocks are the rubber shins nailed to the top or bottom of the wood mounting blocks , if they went on top I assume the bottom would rub against splash apron or do you put a shim on top & bottom ? Or a shims on one side & welting or something on the other ? Thanks
|
03-06-2021, 10:38 PM | #2 |
Senior Member
Join Date: May 2010
Location: brentwood, ca
Posts: 4,214
|
Re: 29 ccpu frame welting & body blocks
https://www.fordbarn.com/forum/showt...ocks+placement
Do a thread search if this doesn't answer you questions good enough. |
Sponsored Links (Register now to hide all advertisements) |
|
03-06-2021, 11:59 PM | #3 |
Senior Member
Join Date: Jul 2011
Location: lawrenceburg, tn
Posts: 128
|
Re: 29 ccpu frame welting & body blocks
I’ve read that post & others I’ve searched but didn’t see anything yes or no about a pad or felt on topside it rear & center body blocks between block & body? It may not hurt anything I just assumed there might be some type of noise if something wasn’t there.
|
03-07-2021, 12:16 AM | #4 |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Re: 29 ccpu frame welting & body blocks
Here is some data that might help you along in some areas:
http://www.plucks329s.org/pdf/studie...EAKARTICLE.pdf Pluck |
03-07-2021, 01:50 AM | #5 |
Senior Member
Join Date: May 2010
Location: brentwood, ca
Posts: 4,214
|
Re: 29 ccpu frame welting & body blocks
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|