Wishbone alignment

[Ross/Kzoo]

Originally Posted by darrylkmc

Hster

If you have a crack similar to the one shown on my Model B engine, I fixed it using 11 each 1/8" solid brass pipe plugs. I started on each of the crack, drilled and tapped halfway each plug and worked towards the middle, ground it near flush then center punched each plug. This was thirty years ago.

I was scratching around on the block trying to find the repair to show someone so I took some photos of it at that time.

I know that there are various ways of repairing cracks, I had read about this method in an old book and gave it a try. It was quick, easy, inexpensive and has lasted flawlessly.

Good luck

Darryl in Frozen Fairbanks

I'm unsure exactly what you did. Could you go into more detail because if it's worked for 30 years that's a definite success.