|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
05-16-2020, 01:08 PM
|
#1 |
|
Junior Member
Join Date: Mar 2015
Location: Santa Clarita, California
Posts: 13
|
82-B CCPU Wood Header Gap Under Visor
Hello All,
I've noticed that it is very typical to find a gap of exposed wood under the visor, and above the sheet metal panel. Is this correct, or should the wood be modified to close that gap? Seems odd that such a large gap would be present, but every car I look at seems to have it. Thx, Scott |
|
|
|
05-16-2020, 02:10 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Auburn Washington
Posts: 2,552
|
Re: 82-B CCPU Wood Header Gap Under Visor
the wood is correct. the same welting that you use around your fenders. goes under the header cover and fill that area in.
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
05-16-2020, 02:31 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,751
|
Re: 82-B CCPU Wood Header Gap Under Visor
Here are some pictures Marco posted.
|
|
|
|
|
05-16-2020, 03:45 PM
|
#4 |
|
Junior Member
Join Date: Mar 2015
Location: Santa Clarita, California
Posts: 13
|
Re: 82-B CCPU Wood Header Gap Under Visor
Trial fit. Does this seem correct?
|
|
|
|
|
05-16-2020, 07:14 PM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: Auburn Washington
Posts: 2,552
|
Re: 82-B CCPU Wood Header Gap Under Visor
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:30 AM.