|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-05-2020, 07:58 AM | #1 |
Member
Join Date: Jul 2019
Posts: 36
|
'34 bent rear spring perches
I'm doing a body off restoration, while having the differential out of the car I noticed the rear spring perches seemed "off". Using a couple of steel stakes in the perches I found this:
Obviously one perch is bent from the other. When looking down from above the right perch (I'm standing at the drive shaft end) looks perpendicular to the differential center line: The left alignment looks like this: No doubt the problem side is the left (in the fore ground of the first image). What can I do about this? Can I heat this forged steel perch to straighten, or am I pooched? Last edited by Leadfoot4U; 10-05-2020 at 08:04 AM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|