Front end tollerences...

[Steve Plucker]

Most of us, if not all, would like to have the front end assembly, when attached to the front cross member and measured from equal points, A to B, left and right, be almost equal.

However sometimes they are not equal.

In other words, pick a point on the front end (A) and measure to a "given" point (B) on the frame, left and right. They should be equal or darn near close to it but sometimes they are not.

With that said...Just how much of a tollerence is acceptable if one can not adjust the "problem", if in fact it is a problem, to get to where both sides are equal? 1/16"?, 2/16"?, 3/16"?

Thanks.

Pluck

[100IH]

Before trying to get that exact on the bumper measurement, put a bag of beans or something similar to 3/4 of the weight of the average weight of a 1929 adult male in the drivers seat. Common practice for alignment if going by the book.

[McMimmcs]

Originally Posted by 100IH

Before trying to get that exact on the bumper measurement, put a bag of beans or something similar to 3/4 of the weight of the average weight of a 1929 adult male in the drivers seat. Common practice for alignment if going by the book.

Never heard of that before but it sure makes good sense. Thanks

[Patrick L.]

Sponsored Links (Register now to hide all advertisements)

If I'm making or pulling a frame I like it to be within 1/16"


When doing alignments If the vehicle is used mostly by one person I leave the pass door open. Of course for crowned roads I set camber and sometimes caster different on each side.