|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-11-2020, 12:17 PM | #1 |
Senior Member
Join Date: May 2010
Location: Burton, Texas
Posts: 681
|
Horn Installation Problem
I’m trying to install my old Spartan horn onto my new wiring harness. How do you get the terminal connector clips open enough to push the bullet connectors in? The old bullet connectors came out of the harness fairly easily with a pair of pliers.
Thank you in advance for any help you can give me with this, Robert |
06-11-2020, 01:05 PM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,753
|
Re: Horn Installation Problem
Here's how they go.
|
Sponsored Links (Register now to hide all advertisements) |
|
06-11-2020, 04:36 PM | #3 |
Senior Member
Join Date: May 2010
Location: Burton, Texas
Posts: 681
|
Re: Horn Installation Problem
Thanks Bob
I thought that the bullet connectors went straight in, but I see in your picture that they go in sideways. I got one in that way with the help of snap ring pliers but broke the other one. I think that I’ll try to solder that bullet connector to the broken connector clip. Thanks again, Robert |
06-11-2020, 06:21 PM | #4 |
Senior Member
Join Date: Jun 2017
Location: Walla Walla, WA
Posts: 1,045
|
Re: Horn Installation Problem
Yep, sideways.
|
06-11-2020, 06:58 PM | #5 |
Senior Member
Join Date: May 2010
Location: Raleigh, NC
Posts: 510
|
Re: Horn Installation Problem
the horn wires clamp under the clips on the motor base, not inside them.
A common mistake...the photo in Bob C. #2 post is correct. |
06-12-2020, 11:53 AM | #6 |
Senior Member
Join Date: May 2010
Location: Burton, Texas
Posts: 681
|
Re: Horn Installation Problem
Sponsored Links (Register now to hide all advertisements)
Thanks again to all of you, Robert |
|
|
Sponsored Links (Register now to hide all advertisements) |
|