Helmet Distributor on the HAMB

[Hoop]

Thought this was interesting.

https://www.jalopyjournal.com/forum/...eeded.1195035/

[35fordtn]

Those are very clearly Dennis carpenter points


Sent from my iPhone using Tapatalk

[Will D]

Sponsored Links (Register now to hide all advertisements)

Had a similar issue with some points I got awhile back from standard. They did not align even after bending back to 90...had to add a spacer below the point block, then sand the top of the block to allow brass washer and c-pin to fit back in while allowing the block to pivot freely. Had more time than money...