The Ford Barn

Tony G · 07-25-2011, 07:54 PM

While sorting through my boxes of spare parts I found a pulley that fits perfectly on the crank but the center hole protrudes out a little more and its threaded internally. The internal threads indicate to me that you dont use the usual ratcheting nut for the A.The pulley diameter is a little smaller than the normal A pulley too. Can this be some part of an aftermarket add on kit? Im stumped.

John LaVoy · 07-25-2011, 11:17 PM

Sponsored Links (Register now to hide all advertisements)

There was a two piece pulley made several years ago that screwed together, you still held it on the crankshaft with the nut. Perhaps that is what you have.

07-25-2011, 07:54 PM	#1
Tony G Member Join Date: May 2010 Location: NewHampshire Posts: 52	Model A front pulley? While sorting through my boxes of spare parts I found a pulley that fits perfectly on the crank but the center hole protrudes out a little more and its threaded internally. The internal threads indicate to me that you dont use the usual ratcheting nut for the A.The pulley diameter is a little smaller than the normal A pulley too. Can this be some part of an aftermarket add on kit? Im stumped. __________________ Old is good, New is bad. Very bad

07-25-2011, 11:17 PM	#2
John LaVoy Senior Member Join Date: May 2010 Location: Rocklin, CA Posts: 1,219	Re: Model A front pulley? Sponsored Links (Register now to hide all advertisements) There was a two piece pulley made several years ago that screwed together, you still held it on the crankshaft with the nut. Perhaps that is what you have.