The Ford Barn

Clem Clement · 11-12-2021, 04:25 PM

Air compressor pressure and engine compression olease.

Kurt in NJ · 11-12-2021, 10:21 PM

I would have to look at the head I have off, if I remember correctly the combustion chamber looks "B"
For sandblasting it run about 45 psi, I regulate the pressure with governor speed to match diameter of nozzle
When it was running a jackhammer I would crank up the governor never measured rpm, suspect around 1800-2200, pressure regulator would kick unloaders about 125

Clem Clement · 11-13-2021, 01:51 PM

Sponsored Links (Register now to hide all advertisements)

THANK YOU
The GWC Club's runs fine but stalls under load. They think it needs rings??

11-12-2021, 04:25 PM	#1
Clem Clement Senior Member Join Date: May 2010 Location: Fairfax, VA Posts: 3,393	Gorden Smith compressor air pressors Air compressor pressure and engine compression olease.

11-12-2021, 10:21 PM	#2
Kurt in NJ Senior Member Join Date: May 2010 Location: on the Littlefield Posts: 6,159	Re: Gorden Smith compressor air pressors I would have to look at the head I have off, if I remember correctly the combustion chamber looks "B" For sandblasting it run about 45 psi, I regulate the pressure with governor speed to match diameter of nozzle When it was running a jackhammer I would crank up the governor never measured rpm, suspect around 1800-2200, pressure regulator would kick unloaders about 125

11-13-2021, 01:51 PM	#3
Clem Clement Senior Member Join Date: May 2010 Location: Fairfax, VA Posts: 3,393	Re: Gorden Smith compressor air pressors Sponsored Links (Register now to hide all advertisements) THANK YOU The GWC Club's runs fine but stalls under load. They think it needs rings??