|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-22-2019, 10:17 PM | #1 |
Senior Member
Join Date: Oct 2010
Location: Oregon and Baja Mexico
Posts: 617
|
Roadster Open Car Windshield Gasket
I have a 1930 Standard Roadster and purchased the Open Car Windshield Gasket for that vehicle. Can anyone show me where it goes and how it gets attached? Contact cement? Should the windshield swing in so the windshield can be laid down flat? Mine hits the metal dash below the windshield frame preventing it swinging in. Seems like the Open Car Windshield Gasket will make it even worse.
|
01-23-2019, 11:57 AM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,755
|
Re: Roadster Open Car Windshield Gasket
Here's a picture of Marco's Roadster. There is a channel on the bottom and sides of
the frame that the rubber slides into. |
Sponsored Links (Register now to hide all advertisements) |
|
01-24-2019, 07:28 AM | #3 |
Senior Member
Join Date: Jan 2019
Location: Germany, near Aachen
Posts: 1,159
|
Re: Roadster Open Car Windshield Gasket
Hello,
Make sure that holes remain open at the bottom of the frame. Otherwise water accumulates in it and the frame rusts.
__________________
Beste Gruesse aus Deutschland, Werner Ford Model A, Roadster, 1928 Citroen 11 CV, 1947 Hercules W 2000, 1976; (with NSU-Wankel Rotary Engine), Canadian version |
01-24-2019, 08:40 AM | #4 |
Senior Member
Join Date: Oct 2010
Location: Oregon and Baja Mexico
Posts: 617
|
Re: Roadster Open Car Windshield Gasket
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|