04-15-2021, 06:42 PM | #1 |
Member
Join Date: Feb 2015
Location: Big Island of Hawai`i
Posts: 43
|
Mystery leak
I'm pouring water in the radiator and it's leaking out the back of the engine. Anybody have any idea what's going on here?
|
04-15-2021, 07:32 PM | #2 |
Senior Member
Join Date: Jun 2014
Location: Melbourne, Australia
Posts: 7,496
|
Re: Mystery leak
Rust through in the water jacket. In a non pressurised cooling system like the Model A, it can be patched but it's engine out to do it.
__________________
I'm part of the only ever generation with an analogue childhood and a digital adulthood. |
Sponsored Links (Register now to hide all advertisements) |
|
04-15-2021, 09:12 PM | #3 |
Senior Member
Join Date: May 2010
Location: Portland OR
Posts: 6,340
|
Re: Mystery leak
Where exactly is it leaking; head, block or?
__________________
I know the voices aren't real but damn they have some good ideas! |
04-15-2021, 10:01 PM | #4 |
Member
Join Date: Feb 2015
Location: Big Island of Hawai`i
Posts: 43
|
Re: Mystery leak
I'm not sure. I can see drops coming off the spot where the flywheel housing bolts to the block. I'll try to pinpoint this.
|
04-15-2021, 10:06 PM | #5 |
Senior Member
Join Date: May 2010
Location: PASADENA, CA
Posts: 1,884
|
Re: Mystery leak
With a mirror and a good light, you should be able to see back there.
Chris W. |
04-15-2021, 10:39 PM | #6 |
Member
Join Date: Feb 2015
Location: Big Island of Hawai`i
Posts: 43
|
Re: Mystery leak
Sponsored Links (Register now to hide all advertisements)
|
04-15-2021, 11:43 PM | #7 |
Senior Member
Join Date: May 2010
Location: Portland OR
Posts: 6,340
|
Re: Mystery leak
It could.
__________________
I know the voices aren't real but damn they have some good ideas! |
04-16-2021, 12:39 AM | #8 |
Senior Member
Join Date: Jun 2014
Location: Melbourne, Australia
Posts: 7,496
|
Re: Mystery leak
All sorts of possibilities. A good look with a light and a mirror should reveal all. Pleas let us know what you find.
__________________
I'm part of the only ever generation with an analogue childhood and a digital adulthood. |
04-16-2021, 07:39 AM | #9 |
Senior Member
Join Date: May 2010
Location: new britain,ct 06052
Posts: 9,390
|
Re: Mystery leak
Before you panic, try re-torqueing the head. FWIW
Paul in CT |
04-16-2021, 07:47 AM | #10 |
Senior Member
Join Date: May 2010
Location: Richmond, VA
Posts: 189
|
Re: Mystery leak
You can remove the floorboards for a better point of view. Most likely it is not good news.
|
04-16-2021, 10:30 AM | #11 |
Member
Join Date: Feb 2015
Location: Big Island of Hawai`i
Posts: 43
|
Re: Mystery leak
Thanks to one and all for the input. I wont be able to get to this today. I will try to hunt down the source of the leak.
|
04-16-2021, 10:33 AM | #12 |
Member
Join Date: Feb 2015
Location: Big Island of Hawai`i
Posts: 43
|
Re: Mystery leak
1931 flamingo. I did retorque the head. Curious that all the nuts were around the 35 pound range. Put them at 55 pounds. I went from 35 to 45 to 55 in the proper sequence. Could this have made a preexisting crack worse?
|
04-16-2021, 10:35 AM | #13 |
Member
Join Date: Feb 2015
Location: Big Island of Hawai`i
Posts: 43
|
Re: Mystery leak
I also found it curious that the car was shipped a gallon and a half low on coolant.
|
04-16-2021, 03:22 PM | #14 |
Senior Member
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 1,908
|
Re: Mystery leak
If it is a gallon and a half low it could be a head gasket and it leaked down to the level of the head gasket. Sounds to be about the right amount of coolant that would have been lost.
__________________
Dave / Lincoln Nebraska |
04-16-2021, 04:11 PM | #15 |
Senior Member
Join Date: Aug 2011
Location: Illinois
Posts: 730
|
Re: Mystery leak
I always had good luck finding cracks in the outer cooling jacket areas by first air blowing everything dry. Then dust the suspected area (s) with talcum powder. The moisture from any crack is then pretty visible. it is just like dusting for finger prints to find the guilty culprit.......
|
04-17-2021, 02:15 PM | #16 |
Member
Join Date: Feb 2015
Location: Big Island of Hawai`i
Posts: 43
|
Re: Mystery leak
Hope to at least look at this today but , I was wondering if a head torqued at 35 lbs. would tend to blow a gasket? I've only driven this car a total of five miles and it's had issues right from the get go.
|
04-17-2021, 07:18 PM | #17 |
Member
Join Date: Feb 2015
Location: Big Island of Hawai`i
Posts: 43
|
Re: Mystery leak
Well, I had the wife pour water in the radiator while I looked at the back of the engine. The water is coming out of the bolt hole, passenger side, at the location where the flywheel housing is bolted and shimmed to the block. Doesn't seem good.
|
04-17-2021, 07:44 PM | #18 |
Senior Member
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 1,908
|
Re: Mystery leak
Might not be so bad. Someone might have put a bolt in that was too long or something along that line and knocked the back of the blind hole open into the water jacket. Pull the bolt out and clean the threaded hole up and seal the coat the threads in the bolt hole and the bolt with Indian Head Shellac or Silicone gasket maker and put it back together again. Wait 24-48 hours and give it a go.
__________________
Dave / Lincoln Nebraska |
04-17-2021, 08:10 PM | #19 |
Member
Join Date: Feb 2015
Location: Big Island of Hawai`i
Posts: 43
|
Re: Mystery leak
It's coming out quite vigorously. Could this scenario still be valid?
|
04-17-2021, 08:14 PM | #20 |
Senior Member
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 1,908
|
Re: Mystery leak
Was it shipped from a location that would have freezing temperatures. If so it could be a freeze crack and that could be more troublesome.
__________________
Dave / Lincoln Nebraska |
|
|
Sponsored Links (Register now to hide all advertisements) |
|