|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-23-2020, 06:00 PM | #1 |
Junior Member
Join Date: Feb 2019
Posts: 14
|
Wiring harness clip location
Hi
Snyder’s sells a clip that bolts to the frame called the, “Light Wire Clip A-14589”. There is a picture of it in one of their older catalogs up near one of the hood hold-downs on the left frame, but I cannot make out where it goes exactly. Can someone please provide a better picture? Thanks Dave |
12-23-2020, 06:11 PM | #2 |
Senior Member
Join Date: May 2010
Location: Lynden, Wa
Posts: 3,551
|
Re: Wiring harness clip location
As far as I know they can go wherever you want them to go. There is no set place as it just keeps the wiring loom in the frame rail. This way it doesn't flop down and get damaged by anything.
Mike
__________________
1930 TownSedan (Briggs) 1957 Country Sedan |
Sponsored Links (Register now to hide all advertisements) |
|
12-23-2020, 07:03 PM | #3 |
Senior Member
Join Date: Oct 2017
Location: Leicester, MA
Posts: 296
|
Re: Wiring harness clip location
That is a bolt on one that they use the same bolt as the latch.
|
12-23-2020, 07:06 PM | #4 |
Junior Member
Join Date: Feb 2019
Posts: 14
|
Re: Wiring harness clip location
Thank you.
I know this is a detail question, but do you know if it was factory on front or rear hood latch bolt? Dave |
12-23-2020, 08:49 PM | #5 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,749
|
Re: Wiring harness clip location
The Standards say it was held by the rear screw of the front hood fastener.
|
12-23-2020, 08:55 PM | #6 |
Senior Member
Join Date: May 2010
Posts: 914
|
Re: Wiring harness clip location
Sponsored Links (Register now to hide all advertisements)
|
12-23-2020, 11:07 PM | #7 |
Junior Member
Join Date: Feb 2019
Posts: 14
|
Re: Wiring harness clip location
That's great! Exactly what I needed to know.
Thank you very much! Dave |
|
|
Sponsored Links (Register now to hide all advertisements) |
|