|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-04-2013, 08:37 AM | #1 |
Senior Member
Join Date: Dec 2012
Location: Brick, NJ
Posts: 189
|
How to pull a Model A engine - step by step
I did a search with no luck. Maybe too much information.
I can probably figure it out but if it's out there somewhere, whay not benefit from the experience and/or mistakes of others? Can anyone point me to a link/website/thread? Pulling the engine and trans as one unit from a 1931 Roadster. |
05-04-2013, 08:54 AM | #2 |
Senior Member
Join Date: May 2010
Posts: 359
|
Re: How to pull a Model A engine - step by step
i have only helped with 5 or 6 pulling and installings, but i can say, it is not practical to try and pull them out attached (engine and transmission) seems one would have to pull the body completely off to achieve this.
Last edited by sunnyorm; 05-04-2013 at 09:15 AM. |
Sponsored Links (Register now to hide all advertisements) |
|
05-04-2013, 09:03 AM | #3 |
Senior Member
Join Date: May 2010
Posts: 359
|
Re: How to pull a Model A engine - step by step
you might want to buy Les Pearson's book "The complete Model a ford instruction manual"
snyder's antique auto parts, and other suppliers have them, they are a little pricey; 69.+ shipping. or les andrew's book |
05-04-2013, 10:44 AM | #4 |
Senior Member
Join Date: Aug 2010
Location: Port Orchard, WA
Posts: 1,498
|
Re: How to pull a Model A engine - step by step
You need to obtain this manual
Model A Ford Mechanics Handbook Vol 1 by Les Andrews http://www.snydersantiqueauto.com/Books/ABooks/2167
__________________
1931 160B & 1931 68B If you don't have time to do it right the 1st time, how do you have time to do it the 2nd time? |
05-04-2013, 12:14 PM | #5 |
Senior Member
Join Date: Nov 2010
Location: Anchorage, Alaska
Posts: 9,115
|
Re: How to pull a Model A engine - step by step
I used the Andrews book when I pulled mine, nice directions and some illustrations.
__________________
Alaskan A's Antique Auto Mushers of Alaska Model A Ford Club of America Model A Restorers Club Antique Automobile Club of America Mullins Owner's Club |
05-04-2013, 07:59 PM | #6 |
Senior Member
Join Date: Dec 2012
Location: Brick, NJ
Posts: 189
|
Re: How to pull a Model A engine - step by step
Sponsored Links (Register now to hide all advertisements)
|
05-04-2013, 08:11 PM | #7 |
BANNED
Join Date: May 2010
Location: Bucks County, PA
Posts: 11,454
|
Re: How to pull a Model A engine - step by step
|
05-04-2013, 08:54 PM | #8 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: How to pull a Model A engine - step by step
I also prefer to pull the engine and tranny seperately, if the body is on the frame.
The engine I installed a couple weeks ago was a tight fit because the owner didn't want to remove the headlight bar. I don't understand some people, as it only takes minutes to remove the bar, and it gives so much more room. |
05-04-2013, 10:02 PM | #9 |
Senior Member
Join Date: Nov 2010
Location: Anchorage, Alaska
Posts: 9,115
|
Re: How to pull a Model A engine - step by step
Well, you know, I didn't have "no stinking book" when I pulled my first Model A engine. But that was 56 years ago and I was 15. If there was a book then I would have had it. A couple years later, I overhauled a Merc-o-matic transmission -- with the aid of a Motors Repair Manual. That wasn't rocket science either, but it sure made the job easier.
I actually thought he was asking for somewhere to find directions on how to do it. I guess I was wrong.
__________________
Alaskan A's Antique Auto Mushers of Alaska Model A Ford Club of America Model A Restorers Club Antique Automobile Club of America Mullins Owner's Club |
05-04-2013, 10:09 PM | #10 | |
Senior Member
Join Date: May 2010
Location: Portland, Oregon
Posts: 5,906
|
Re: How to pull a Model A engine - step by step
Quote:
My father used to say, "There are four ways to do something: my way; your way; the wrong way; and the right way. Sometimes these overlap." Good luck; let us know how you do. And thank you, Jeff, for your comment.
__________________
Ray Horton, Portland, OR As you go through life, keep your eye on the donut, not the hole. Last edited by 700rpm; 05-04-2013 at 10:18 PM. Reason: Spelling correction |
|
05-05-2013, 03:47 AM | #11 |
Senior Member
Join Date: May 2010
Location: Bucks Co, Pa
Posts: 3,740
|
Re: How to pull a Model A engine - step by step
I suspect he was being facetious. Didn't I read somewhere that the normal time for an experienced person is under an hour?
Terry |
05-05-2013, 03:55 AM | #12 |
Senior Member
Join Date: Jan 2011
Location: New Zealand
Posts: 670
|
Re: How to pull a Model A engine - step by step
My book is called "The Complete Model 'A' Ford Restoration Manual". Contact Mike's Affordable Parts.
The retail price is set by the retailer, not me. Cheers. Les. Pearson.
__________________
R.H.D. Author of Model 'A' Ford technical manuals. Supplier of good original RHD parts. |
05-05-2013, 04:13 AM | #13 | |
Senior Member
|
Re: How to pull a Model A engine - step by step
Quote:
Send me the parts you have left over when your done.
__________________
What's right about America is that although we have a mess of problems, we have great capacity - intellect and resources - to do some thing about them. - Henry Ford II |
|
05-05-2013, 05:36 AM | #14 |
Senior Member
Join Date: May 2010
Location: Central FL, USA
Posts: 1,138
|
Re: How to pull a Model A engine - step by step
When I got my first Harley the first thing I bought for it. Was the factory service manual, one of the best in the world. Same with any vehicle I get into, 2 or 4 wheels. And when I sell any vehicle I always keep the manuals. Because I know I will need them again.
Bob-A |
05-05-2013, 07:23 AM | #15 |
Member
Join Date: Jan 2011
Location: Central Maryland
Posts: 96
|
Re: How to pull a Model A engine - step by step
I removed my engine and transmission as a unit this past winter. I also had the benefit of several guys from our club helping me since they had done this before. Took about 2.5 hours since they were teaching me as we went along (they are great guys!) sharing their techniques for removing the hood, light bar, headlight wiring, etc. It took a bit longer to reinstall the engine/transmission and put everything back together. I found that removing the front bumper gave us more room to maneuver the engine hoist. A frame spreader was very helpful to gain that needed 1/8th of an inch or so to allow the engine to slip right into the rear engine mounts. For all the other reinstallation actions working by myself, I had the Les Andrews book by my side which was very helpful.
|
05-05-2013, 07:23 AM | #16 |
Senior Member
Join Date: Dec 2012
Location: Brick, NJ
Posts: 189
|
Re: How to pull a Model A engine - step by step
I didn't mean to offend the Forum or Les.....as I recall, I used a line out of a Cheech and Chong movie. "I don't need no stinking ______", I just added the "book". I guess it lost it's humor in the translation.
I always appreciate the recommendations and comments of this and all forums. Otherwise I wouldn't have asked the question. BTW, I did order the book from Amazon. I know there is something in there I will need for reassembly! Last edited by skryla; 05-05-2013 at 04:06 PM. |
05-05-2013, 07:51 AM | #17 |
Senior Member
Join Date: Jan 2012
Location: Tx
Posts: 502
|
Re: How to pull a Model A engine - step by step
|
05-05-2013, 07:53 AM | #18 |
Senior Member
Join Date: Sep 2011
Location: Alton, NH
Posts: 1,231
|
Re: How to pull a Model A engine - step by step
When I read your post, I suspected that was an idle stab at humor. That is a good line, used it lots myself, it does not translate well in text. Good luck and keep us posted
__________________
It's not what people think they know that will hurt them, it is what they think they know that aint so! -Mark Twain. It is the very things that we think we know, that keep us from learning what we should know.- Unknown |
05-05-2013, 08:53 AM | #19 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: How to pull a Model A engine - step by step
As I mentioned earlier, I think it's easier to remove the engine by itself, but either way, be sure to remove the throttle cross linkage first, and keep track of the brass shims under the two mounting ears.
|
05-05-2013, 09:00 AM | #20 |
Senior Member
Join Date: Mar 2012
Location: Napa CA
Posts: 412
|
Re: How to pull a Model A engine - step by step
Having had the pleasure of pulling the engine on my Model A more than once (as I’m certain many – if not most - other FordBarner’s have) I read this thread with passing interest. Accordingly, I apologize (in advance) for the following detour:
FWIT (probably not much) the “Stinkin’ badges” line originated in the 1927 novel The Treasure of the Sierra Madre by B. Traven (which was the pen name of the German author Ret Marut) and was later popularized in the 1948 film of the same name, staring Humphrey Bogart (who never made a bad movie), Walter Huston and Tim Holt. The director was John Huston, Walter Huston’s son. In the novel, the line was (further apologies for the language): “Badges, to g**-damned hell with badges! We have no badges. In fact, we don’t need badges. I don’t have to show you any stinking badges, you g**--damned cabron and c***** tu madre!” In the movie, the line – spoken by the character Gold Hat played by Alfonso Bedoya, one of the great and largely unheralded Mexican character actors who appeared in roughly 175 Mexican films and a great many US films - became “Badges? We ain’t got no badges. We don’t need no badges. I don’t have to show you any stinkin’ badges.” The character Gold Hat was later executed by Mexican Federales (but not for saying this line). The rest – as with the line “Play it again, Sam” (another often misquoted line, this time from Casablanca, another great Bogart movie) – is history, and generally misquoted as “We don’t need no stinkin’ badges/books/seat belts/etc.” In fact the line has become so widely used (in its misquoted format) that the list of such use is legend, and includes Blazing Saddles, WKRP in Cincinnati, Stephen King’s novel It, and so on (although I didn’t note any reference to Cheech and Chong). Just something to reflect on while taking a break with your Model A engine (hopefully sans transmission, as recommended by others) suspended in mid-air…
__________________
Skip Keyser Napa Valley A's Olympic Vintage Auto Club (1980-1982) MARC of San Diego (1977-1978) MAFCA (since 1978) MARC (since 1977) ---------- Model A owners belong in their Model A’s; Model A’s belong on the road. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|