|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-05-2020, 10:36 PM | #21 |
Senior Member
Join Date: Jan 2011
Location: sw minnesota
Posts: 4,578
|
Re: 35 spindles and axle worn. Looking for a needle thrust bearing
dan, in summery, most of us are trying to say you dont have a problem. some pictures would say a lot here, best wishes
|
06-06-2020, 05:44 AM | #22 |
Senior Member
Join Date: Jul 2010
Location: Cairns , Australia
Posts: 746
|
Re: 35 spindles and axle worn. Looking for a needle thrust bearing
Thank you to all I’ll get a shim made to take up the gap leaving enough to put the felt washer in. Dan.
|
Sponsored Links (Register now to hide all advertisements) |
|
06-06-2020, 08:09 AM | #23 |
Senior Member
Join Date: Jan 2011
Location: Central Ohio
Posts: 5,070
|
Re: 35 spindles and axle worn. Looking for a needle thrust bearing
I'll take a look today. I think the other thing we were trying to point out is that it is really not a wear gap - there is no metal to metal contact on this section of the axle. The gap is supposed to be there (was there from the factory) - it wasn't caused by usage or abuse . . .
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|