3 bolt-2 bolt dizzy adapter parts

[johndee138]

I have a 3 bolt to 2 bolt dizzy adapter on my 39 motor so I can run the 2 bolt crab dizzy. I have just swapped out one intake for another, and I need to make the vacuum brake plumbing hook up since the intake port is in a different place. WHERE on EARTH can I get the little brass fittings to complete this connection WITHOUT having to buy another complete adapter?

[Mac VP]

We have the little brass fittings that go on the end of the vacuum tubing. It slides on to the fresh tube then compresses onto it when tightened down. I forgot the thread size but we just got a supply of them in. Call our sales office Monday if you still need some.

[OLDMANKOHOUT]

Sacramento Vintage Ford, but VP is a bit closer!! Line with banjo fitting is no longer available from us.



https://www.vintageford.com/word_sea...CUUM&Category=

[deuce_roadster]

If you look up "ford nut" I think any NAPA that has Weatherhead brand fittings would have what you want. It is a compression nut that the taper on the end takes the place of a ferrule used on modern compression fittings. C&G, Carpenter and Drake I think stock them.

[35fordtn]

Ford also used three different varieties of the fitting in question. One variety had the same hole size but accepted a 1/2” wrench versus a 7/16”. There was another variety used only in wiper motor tube connections

Personally I feel as though the vacuum brake vacuum is not needed on today’s octane level fuels. I still run the tube for looks but plug off the inside of it

[deuce_roadster]

Sponsored Links (Register now to hide all advertisements)

I agree with 35fordtn, the swamp water we buy as gas doesn't need it.