36 LED tail light inserts

[johndee138]

I anyone offering LED tail light inserts for a 36?
I don't want or need the housing, trim or lens.
I would prefer white LEDs instead of red, so my blue dots are blue and the license plate illumination is white.
I'm 12v as well.

[deuce lover]

Retract

[Joe Immler]

Try Checkrite Electronics I got LED conversion ail lights for my '41 and am very pleased.
Ken Check 541 653 8825 [email protected]

[billybronco1]

I purchased 6 volt non polarity led 1157 white bulbs on eBay. Just replace standard bulb with led, should work with most directional signal units. I did use a single element for the fronts, they work great, super bright. Still waiting to receive and try the dual elements for the rears. I will post an update once I test them out.

[fordor41]

Rodtiques sells LED '36 ford tail light lens. I installed LED lens in my '41. super bright. Mine came from United Pacific. May have to go with no load flasher

[terry]

Sponsored Links (Register now to hide all advertisements)

I needed to do the same as fordor 41 and install a different flasher after i put LED flashers in the back window of my fordor 36. Terry

[billybronco1]

Not sure if the turn signals come standard with a 12 volt bulb in the unit itself, it barely lit up. Took me a while but I found a 6 volt bulb that fit inside the unit, nice and bright now. Directionals also work great with 6 volt third brake light in the rear window.

[fordor41]

Originally Posted by terry

I needed to do the same as fordor 41 and install a different flasher after i put LED flashers in the back window of my fordor 36. Terry

instead of a no load flasher you can wire in a incandescent bulb in the trunk ,out of sight, on both sides and that will make the regular flasher unit operate

[billybronco1]

I tried installing LED bulbs in the rear lights and the flasher will not flash. I have LED in the front and a rear window Brakeklighter, with standard bulbs in the rear all works fine. Some people say install a resister. Where would you put the resistor and what size?