|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-21-2011, 07:22 AM | #1 |
Senior Member
Join Date: May 2010
Location: Gardiner Me.
Posts: 4,200
|
B engine in a Model A for Turner
Turner, your e-mail wouldn't go through. call me 207-485-0707 Walt
|
10-28-2011, 08:29 PM | #2 |
Junior Member
Join Date: Jun 2010
Location: Mechanicsville, VA
Posts: 17
|
Re: B engine in a Model A for Turner
Walt, Do you know of anyone who makes "rigid" rear mount for installing the B engine? I've seen the float-a-motor kits, but I would prefer a rigid mount. Thanks for the reply. Lee Turner
|
Sponsored Links (Register now to hide all advertisements) |
|
10-28-2011, 08:47 PM | #3 |
Senior Member
Join Date: May 2010
Location: Gardiner Me.
Posts: 4,200
|
Re: B engine in a Model A for Turner
If your going to use the Model A trans, you'll have to cut the flywheel cover off the B oil pan and use the A bell housing. Then you can use the A rear mounts. Walt
|
10-31-2011, 06:47 PM | #4 |
Junior Member
Join Date: Jun 2010
Location: Mechanicsville, VA
Posts: 17
|
Re: B engine in a Model A for Turner
Walt, I'm looking to use the B flywheel housing, B pan, and B trans. In your case, did you use the "float-a-motor" kit for the rear installation? I've seen that offered for the B flywheel housing. I'm looking for a rigid rear mount for the B flywheel housing. Lee
|
10-31-2011, 07:26 PM | #5 |
Senior Member
Join Date: May 2010
Location: Gardiner Me.
Posts: 4,200
|
Re: B engine in a Model A for Turner
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|