|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
06-27-2020, 03:32 PM
|
#1 |
|
Senior Member
Join Date: Nov 2010
Location: SPRUCE PINE NC
Posts: 446
|
29 Tudor crank pulley question
I was reinstalling the generator that I just rebuilt and I noticed that the two piece crank pulley had some play between the pulley piece and the separate rear piece.
It is not a lot of play but I'm thinking that there should not be ANY play at all. The pulley bolt is tight so I am wondering why there is play?? Also--can I tighten that bolt with a socket and extension through the crank hole in the radiator shell--what size socket??? Any thoughts?
__________________
Why is there never enough time to do it right, but always enough time to do it over!!! |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:21 AM.