|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-28-2014, 11:39 AM | #1 |
Senior Member
Join Date: Jul 2014
Location: FRANKSTON TX
Posts: 117
|
Distributor clamp ears repair
Has any one ever used brass to repair distributor clamp ear that is broken off, tip on tightening amp ring to dash.
Thanks dana |
07-28-2014, 12:10 PM | #2 |
Senior Member
Join Date: May 2010
Location: brentwood, ca
Posts: 4,246
|
Re: Distributor clamp ears repair
probably easiest repair for the distrib ear is replace casting/core.
I would have trouble with alignment and positioning depending on the amount broken off. why mess with it? Bob |
Sponsored Links (Register now to hide all advertisements) |
|
07-28-2014, 02:23 PM | #3 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Distributor clamp ears repair
I have brazed and also silver soldered broken ears, both are very successful.
I have another one that the broken ear is missing, so I'll build it up using an oxy/acc torch and cast iron rod with blue flux. So far the only place I've found the cast iron gas welding rod is the welding shop in Watertown, S.D. |
07-28-2014, 03:49 PM | #4 |
Senior Member
Join Date: Mar 2014
Location: Midland Park,N.J.
Posts: 1,108
|
Re: Distributor clamp ears repair
I would find a good casting but don't throw away the broken one,it could be fixed and used someday
|
07-28-2014, 05:35 PM | #5 |
Senior Member
Join Date: May 2010
Location: Marengo. Illinois
Posts: 262
|
Re: Distributor clamp ears repair
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|