|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-29-2020, 07:23 AM | #1 |
Senior Member
Join Date: Sep 2013
Posts: 3,005
|
installing windshield rubber gasket.
Is the groove in the windshield frame supposed to be tight enough to retain the rubber gasket without the use of adhesive? this is especially noticeable along the lower portion of the frame?
|
07-29-2020, 07:44 AM | #2 |
Senior Member
Join Date: May 2010
Location: Southern France
Posts: 5,306
|
Re: installing windshield rubber gasket.
Yes,push it in with a thin putty knife.Groove must be clean.
|
Sponsored Links (Register now to hide all advertisements) |
|
07-29-2020, 02:12 PM | #3 |
Senior Member
Join Date: Feb 2020
Location: Hayward,CA
Posts: 513
|
Re: installing windshield rubber gasket.
My F1 windshield was put in without adhesive. It stays in just fine, but when I drive in the rain there’s always a couple of streams of water running down the top of the dash panel.
. |
07-29-2020, 02:28 PM | #4 |
Senior Member
Join Date: May 2010
Location: Southern France
Posts: 5,306
|
Re: installing windshield rubber gasket.
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|