|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-15-2012, 05:29 PM | #1 |
Senior Member
Join Date: May 2010
Location: Levelland, Tx
Posts: 418
|
'40 springloaded accelerator linkage
I am having a problem installing the 91A-2725 accel. mech. that is bolted to firewall(2 bolts) between the floor pedal and the carburator.
the spring is so tight I cannot install with spring on, so I thought maybe I could bolt it on without spring loaded and hook up spring afterward. what am I doing wrong? pics included. while working alone, i used masking tape to hold it up 'till I bolted it on and I used masking tape on the spring to protect the paint. what (all) am I doing wrong? I receive instructions graciously....... thanks, fordman |
07-15-2012, 05:32 PM | #2 |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 9,007
|
Re: '40 springloaded accelerator linkage
[QUOTE=fordman;461663]I am having a problem installing the 91A-2725 accel. mech. that is bolted to firewall(2 bolts) between the floor pedal and the carburator.
the spring is so tight I cannot install with spring on, so I thought maybe I could bolt it on without spring loaded and hook up spring afterward. what am I doing wrong? pics included. while working alone, i used masking tape to hold it up 'till I bolted it on and I used masking tape on the spring to protect the paint. what (all) am I doing wrong? You are not doing anything wrong. When attempting to install this assembly by yourself, it can be a bit of trouble. It is easier to have someone place it through the cowl while another working inside the car starts threading the nuts.
__________________
"I can explain it for you. However, I can't understand it for you". |
Sponsored Links (Register now to hide all advertisements) |
|
07-15-2012, 11:19 PM | #3 |
Senior Member
Join Date: May 2010
Location: Levelland, Tx
Posts: 418
|
Re: '40 springloaded accelerator linkage
I finally got it installed by following 'charles in east texas' suggestion to install passenger side nut first and work it around until you can get driver side in. I started without the spring compressed; after the pass. nut was installed I compressed the spring then put the driver nut in.
charles in east texas is in another version of this thread. i regret the mess of multiple copy of the problem; it started with pic probs and cockpit problems your words were an encouragment to keep trying thanks, fordman |
12-07-2015, 08:57 PM | #4 |
Member
Join Date: Oct 2015
Location: columbia tn
Posts: 51
|
Re: '40 springloaded accelerator linkage
Sponsored Links (Register now to hide all advertisements)
Bob |
|
|
Sponsored Links (Register now to hide all advertisements) |
|