Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 08-18-2015, 09:09 AM   #1
Robz51
Member
 
Robz51's Avatar
 
Join Date: May 2010
Location: Rogers, AR
Posts: 97
Default 52 Merc wiring harness question.

I am starting the process of rewiring my 52 Merc Monterey hardtop. Didn't plan on doing this now but due to numerous electrical issues I'm forced into it. My question is about the harness to the tail/backup lights and fuel sending unit. It seems to start under the dash on the lh side and go into a hole above the kick panel. Do I need to remove the front fender to access the harness? This is the original harness. Any help would be appreciated.
Rob Jones
Robz51 is offline   Reply With Quote
Old 08-18-2015, 09:31 AM   #2
redtriford
Junior Member
 
Join Date: Dec 2012
Location: central NY state
Posts: 27
Default Re: 52 Merc wiring harness question.

Sponsored Links (Register now to hide all advertisements)
The wire that goes in the hole above the kick panel goes down the body behind the fender and is held by a clamp half way down, from there it enters the front of the rocker panel. You can access every thing by removing the panel that is behind the rear wheel.
Ray
redtriford is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:24 AM.